Mantis 7945 Manual del operador descargar pdf (Pagina 8)

8 Operator’s Manual

Assembly (Continued)

UPPER HANDLE ASSEMBLY

• Lightly squeeze the lower

handles (T3) toward one another

so that they line up with the two

smaller holes on the carrying

handle (T10). Then slide the

carrying handle over and down

the lower handles. It will rest

about four to six inches above the

fender.

• Gently pull the lower handles out

to their original position.

• Your Mantis Tiller will look like

this when the lower handle

assembly is complete.

7a

7b

8

• Lift the upper handle until it lines up

with the lower handle.

•

Insert carriage bold (T42) from outside in.

• Screw on knob (T12) and fully tighten

the knob at the pivot point.

• Follow the same steps to install the

other upper handle onto the other

lower handle.

• Use the clip (T9) to secure the throttle

cable and wire in place on the lower

handle.

10

9

• Cap the exposed bolt with an acorn

nut (T13) and tighten with your 7/16”

wrench until snug. Do not over tighten.

• Now install the handle brace. Line it up

with the holes on the upper handles.

Then insert a cap screw (T15) and a

lock nut (T14) on either side.

• Use a wrench to tighten cap screws

and lock nuts.

• Now use wrench to tighten all nuts and

bolts rmly and securely.

11

• Position the kickstand brace just above the

bend of the lower handles.

• Position the kickstand under the lower

handles, line up the holes and thread the

kickstand brace bolts into the kickstand.

•Tighten with the 3/8” wrench.

• Your Mantis tiller will look like

this when lower handle assembly

and kickstand is complete.

KICKSTAND ASSEMBLY (If your tiller comes with a kickstand)

1 2 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comentarios a estos manuales

Sin comentarios