Mantis 5000 Especificaciones descargar pdf (Pagina 14)

Figure 11: The Cary 4000, 5000 and 6000i Internal Diffuse Reflectance accessory

with the optics cover removed. The large reference plate is clamped over the

reflectance port at the centre of the sphere cap.

Warning

This accessory contains electrical circuits, devices, and components

operating at dangerous voltages. Contact with these circuits, devices and

components can cause death, serious injury or painful electrical shock.

To prevent electrical shock operators and other unauthorized personnel

must never remove the cover. This must be opened only by Varian-

trained, Varian-qualified or Varian-approved service engineers.

7. Position the accessory so that the two rear lock-down feet are situated at the

back of the sample compartment and gently lower the accessory so that the

front pin on the base plate fits into the post clamp on the sample compartment

floor. Ensure that the base of the accessory is parallel to the sample

compartment floor.

8. Slide the lever at the front of the sample compartment to the left, to lock the

base plate into position.

Caution

Do not plug the DRA into the spectrophotometer when the latter is turned on, or

electronic damage may occur.

9. Take the clamp post from under the foam in the wooden shipping case and

fasten it in the hole in the accessory cap. Place the sample clamp on the clamp

post.

Alignment

Warning

To avoid eye damage use care when looking into the various ports

during the alignment process. Do not look into the light beams.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 48 49

Sin comentarios

Mantis 5000 Especificaciones Pagina 14